Collective Operation Setting - Mitsubishi Electric G-50A Instruction Book

4 - 2 - 2 Collective operation setting

• A collective operation setting and a collective prohibit setting can be performed for all the group managed by
this controller at one time.
(1) Collective operation setting
The collective setting is executed.
The collective setting takes approximately 20
seconds.
The display of setting contents is erased
NOTE:
when shift to another screen.
1 Press the
display and press the
screen.
2
The collective operation setting initial screen is displayed.
3 Select the items for operation setting on the collective operation setting
initial screen.
The operation method is same as described in section "4-2-1 Group
operation setting" (Page 12).
The items which were not set, remain set to the same
NOTE:
condition that were set before the collective operation was
performed.
4 The items selected for the operation blink on the collective operation
setting screen.
5
When all setting are completed, press the
the "SET" in blinking display for the indicated function area.
6
Press the switch one time to complete this setting.
ENTER
The collective setting is completed when the previous
items light. (After the setting are completed, start
from step
operation are required.)
-16-
switch to set "COL. (COLLECTIVE)" in blinking
switch on the group operation setting
ENTER
to perform operation again if change
3
switch to display