Ptz Setup - KGuard Security SHA14 User Manual

Chapter 4: Using the DVR
7
After all settings are complete, click Apply.
8
When data saving is complete, click OK.
Note:
When email setup is complete, click Test to check if your email settings are properly configured.

4.4.3 PTZ Setup

After the PTZ speed dome is properly installed via RS-485 connection, you can customize its settings using the PTZ
SETUP menu.
To set up the PTZ camera setting, do the following:
1
In preview mode, right-click on the mouse to display the Pop-up menu.
2
Select Main Menu > DEVICE > PTZ.
3
Select the channel which the PTZ camera is connected to.
4
Set the PTZ Protocol, Baud Rate, Data BIT, Stop BIT, Parity, Address code.
4
Enable or disable Cruise mode.
5
After all settings are complete, click Apply.
6
When data saving is complete, click OK.
Note:
The PTZ camera can only be activated when a connected channel with the PTZ camera is selected.
DVR User's Manual
42