TP-Link TL-MR6400 User Manual page 44

Wireless Network Name - Enter a value of up to 32 characters. The same Name (SSID)

must be assigned to all wireless devices in your network.
Region - Select your region from the pull-down list. This field specifies the region where

the wireless function of the router can be used. It may be illegal to use the wireless
function of the router in a region other than one of those specified in this filed. If your
country or region is not listed, please contact your local government agency for
assistance.
Mode - Select transmission mode according to your wireless devices.

Channel Width - The bandwidth of the wireless channel.

Channel - This field determines which operating frequency will be used. It is not necessary

to change the wireless channel unless you notice interference problems with another
nearby access point. If you select auto, then AP will choose the best channel automatically.
Enable Wireless Router Radio - The wireless radio of the router can be enabled or

disabled to allow wireless stations access. If enabled, the wireless stations will be able to
access the router. Otherwise, wireless stations will not be able to access the router.
Enable SSID Broadcast - If you select the Enable SSID Broadcast checkbox, the wireless

router will broadcast its name (SSID) on the air.
Enable WDS Bridging - You can select this to enable WDS Bridging, with this function, the

router can bridge two or more WLANs. If this checkbox is selected, you had better make
sure the following settings are correct.
TL-MR6400 300Mbps Wireless N 4G LTE Router
Figure 4-18 Wireless Settings
-32-