TP-Link TL-MR6400 User Manual page 35

Step 2: Press and hold the WPS button of the client device directly. The WPS LED flashes for
two minutes during the Wi-Fi Protected Setup process.
Step 3: When the WPS LED is on, the client device has successfully connected to the router.
II. Enter the client device's PIN on the router
Use this method if your client device does not have the WPS button, but has a Wi-Fi Protected
Setup PIN number.
Step 1: Keep the default WPS Status as Enabled and click the Add Device button in
, then the following screen will appear.
4-2
Step 2: Enter the PIN number from the client device in the field on the WPS screen above.
Then click Connect button.
Step 3: "Connect successfully" will appear on the screen of Figure 4-4, which means the
client device has successfully connected to the router.
III. Enter the router's PIN on your client device
Use this method if your client device asks for the router's PIN number.
Step 1: On the client device, enter the PIN number listed on the router's Wi-Fi Protected Setup
screen. (It is also labeled on the bottom of the router.)
Step 2: The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected
Setup process.
Step 3: When the WPS LED is on, the client device has successfully connected to the router.
Step 4: Refer back to your client device or its documentation for further instructions.

Note:
1) The WPS LED on the router will light for five minutes if the device has been successfully
added to the network.
TL-MR6400
Figure 4-3 Add A New Device
Figure 4-4 Add A New Device
-23-
300Mbps Wireless N 4G LTE Router
Figure