TP-Link TL-MR6400 User Manual page 37

Connection Status - Shows whether the Internet is connected or disconnected at present.

Mobile Data - It is enabled by default. You can disable it to prohibit Internet access.

Data Roaming - It is disabled by default. If disabled, data service is not allowed when

roaming. If enabled, data service is allowed when roaming, but may incur significant
roaming charges.
Network Mode - The device supports three modes of network connection - 4G Preferred,

4G Only, 3G Only. If your SIM card supports WCDMA, select 3G only; if your SIM card
supports LTE, select 4G Preferred or 4G only as you need.
Profile Name - A list of profile for you to select. After selecting one profile from the list, you

can further modify its parameters. Show the name of the profile you've selected here.
PDP Type - Select the type of your PDP (Packet Data Protocol).

APN Type - Select the type of your APN, either Dynamic or Static. If you select Dynamic,

the device will have dynamic APN, which does not need to be specified. If you select Static,
you can manually specify your APN.
APN - Access Point Name, provided by your ISP. You need to set APN only after selecting

the static APN type. You are recommended to keep the default value.
Username/Password - Enter the username and password provided by your ISP. These

fields are case-sensitive. You are recommended to keep the default value.
Authentication Type - Some ISPs need a specific authentication type, please confirm it

with your ISP or keep the default value.
• None - No any authentication is needed.
• PAP - Password Authentication Protocol. This protocol allows the device to establish
TL-MR6400 300Mbps Wireless N 4G LTE Router
Figure 4-7 Dial Up
-25-