Mounting The Tail Wheel Bracket; Installing The Switch - Seagull Models HARRIER 3D .46 Assembly Manual

HARRIER 3D .46
5) Rudder pushrods assembly follow picture
below.

MOUNTING THE TAIL WHEEL BRACKET.

1) Set the tail wheel assembly in place on
the plywood plate. The pivot point of the tail
wheel wire should be even with the rudder
hinge line and the tail wheel bracket should
be centered on the plywood plate.
2 Using a pen, mark the locations of the two
mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
3) Secure the tail wheel bracket in place us-
ing two 3mm x 15mm wood screws. Be care-
ful not to overtighten the screws.
MOUNTING THE CONTROL CLASP.
1) Align the tail wheel wire so that the wire
is parallel with the bottom of the rudder. The
control clasp has a predrilled hole through the
top of it. Slide this hole onto the tail wheel wire
while sliding the clasp over the bottom of the
rudder.
2) Using a ruler and a pen place a mark onto
the bottom of the rudder, in front of the rear
edge of the tail wheel wire. The back edge of
the clasp should line up with this mark.
You may find it necessary to bend the tail wheel
wire down slightly so it lines up with the clasp
without binding.
3) While holding the clasp firmly in place,
use a pen and outline the clasp onto the rud-
der.
4) Remove the clasp, and using a modeling
knife, remove the covering from inside the lines
you drew. Use 220 grit sandpaper and care-
fully roughen the inside surface of the nylon
clasp.
Instruction Manual.
5) Slide the clasp back into position and
carefully glue it into place using Kwik Bond Thin
C/A. Hold the clasp in place until the glue com-
pletely cures. Rescue the clap with bolt and
nut as picture below.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
fuselage side. Use the two screws provided
with the switch to secure it in place. Drill two
3/32" holes through the tray for the screws to
pass through.
Control clasp.
17