System Setup; Power Mode Setup; Cs Setup; Ecp Address Selection - Honeywell Tuxedo Touch WIFI Installation And Setup Manual

From System Setup, you may access Power Mode Setup, CS Setup, User Setup, Time/Date Setup, and Advance
Setup.

Power Mode Setup

Power Setup Mode allows you to reduce power consumption in the event of a system trouble such as AC Loss or Panel
Low Battery. To access Power Mode Setup, from the "Home" screen do the following:
ICON
1. Press the Setup icon and then
the System Setup icon.
2. Press the Power Mode Setup
icon.
3. Enter your Authorized Code, if
required.
4. Select Power Save Mode to
enable; then choose from the
options.
5. Press Apply to save settings.

CS Setup

You may access ECP/RIS Automation Address, CS Options/Operating Modes, Screen Security, Device Events,
Code Authority and Panel Configuration from the CS Setup screen.
From the "Home" screen, press the Setup and System Setup icon and perform the following:
ICON
1. From the System Setup screen,
press the CS Setup icon.
2. Enter your Authorized Code, if
required.
3. Press the ECP Address icon.

ECP Address Selection

After enabling addresses in the control panel using an alpha-keypad, power-up each keypad one at a
time, and set its address to one of the addresses you enabled in the control panel. Otherwise, access the
Central Station screen then follow this procedure to change the address on the unit.
To change the address, perform the following:
ICON
1. Press the ECP Address icon.
1
2. Select the ECP address for this keypad
2
3
using the Up/Dn arrows.
3. The available ECP addresses are:
1-2, 5-6 for residential controls
1-2, 3-30 for older commercial controls
under Rev. 10 supports 3
AUIs. *See Important Note
below.
1-30 for commercial Turbo controls

System Setup

ACTION
ACTION
ACTION
Select from:
• Turn-off Network
• Override Display Settings: When selected, Display settings
are overwritten and the keypad operates in low power mode:
- Brightness/Volume controls decrease to minimum levels.
- Return To Homepage After time resets to 30 seconds.
- Auto SlideShow After time reverts to Never.
When AC power is restored, the original Display settings
resume.
If the top of the screen is displaying "ECP Error", the ECP
address in the keypad is not valid for the panel that it is
connected to. In this case, to change the ECP Address, enter
the default code of "4140" to advance to the next screen.
Note: Default code "4140" is the Tuxedo Touch default
installer code before connecting to a control panel. Once
connected to a control panel, use that panel's installer code.
When the keypad cannot communicate with the alarm
panel, the message "ECP Error" is displayed, check the
following:
• Verify that the AUI type device is enabled in the
control panel, and that the ECP address in the keypad
matches the address enabled in the control panel.
Use a different address for each device.
• If powering the keypad from a power supply, make
sure you have a common ground installed
(wiring between Power Supply "gnd" and panel "Aux.
power neg").
22
NOTES
NOTES
NOTES