Honeywell Tuxedo Touch WIFI Installation And Setup Manual page 14

ACTION
2. At your PC:
a) Open the browser and enter the IP
Address displayed on the keypad into your
browser.
Network Connections
To set up network connections, from the "Home" screen, and do the following:
ICON
1. At the Tuxedo Touch keypad:
a) Press the Setup icon.
b) Press the IP Setup icon.
2. Select a type of network connection
LAN ON or WIFI ON and go to that
section below for further information.
Setup a LAN Connection
From the IP Setup screen, add a LAN network connection as follows:
ICON
1. At the Tuxedo Touch keypad:
a) Press the LAN ON button.
- Connect an Ethernet cable between
the router and the keypad; the IP
address and default gateway address
of the router is displayed.
- If the IP address is not displayed,
change the "Internet Connection
Type" to Static to manually enter
the IP address from your router onto
the keypad. Highlight each field and
enter the required information on
the "Data Entry Keyboard" for
Subnet Mask, Default Gateway,
DNS Server and Port #; press GO.
2. Press the Save icon; the IP information
will automatically update.
3. At your PC, Smart Phone or Tablet
browser, start your browser and enter
your IP Address.
Initial Setup (cont'd)
The IP Address is displayed in the lower left-hand corner on
the Tuxedo Touch Keypad "Home" screen.
NOTE: If using an iPad, iPhone or PC browser with low
bandwidth on the mobile type theme, to switch between
normal theme and mobile theme, go to the Home page on
the Web browser and press the Switch Theme icon; the
user interface displays the mobile theme. Web themes for
Android phones and Tablets are not supported.
ACTION
:
ACTION
14
NOTES
NOTES
A pop-up window displays the message:
Save the Change
Select Yes to save the settings.
NOTES
A pop-up window displays:
This will switch off WLAN Network, do you want
to continue? Yes or No
Use the Data Entry Keyboard to enter the required
information.
• Press the "up arrow" to switch to capital letters.
• Press the Space key to add a space between
characters.
• Press the x key to delete/backspace.
• Press the ABC/123 key to switch between
numerals and symbols/characters.
• Press GO to return to the IP Setup screen.
Note: To change the default port number (6280),
press the field next to port number and on the data
entry keyboard enter a secondary port number
between 5000-65534. Press GO and then press
Save.
A pop-up window displays:
Success Network Details Saved
Port number changed. Keypad is going to reset
The keypad will reboot with the newly configured
port number.