Honeywell Tuxedo Touch WIFI Installation And Setup Manual page 20

ICON
7. When all cameras have been added,
press the Camera WIFI icon to enter
the camera wireless settings
information from your router.
8. Press Apply to All to set cameras for
wireless operation.
9. Press the Save icon.
10. Press the Settings icon to enter
Video, Network, Wireless, and Other
settings; refer to "(Advanced Camera)
Settings" below.
11. Remove the Ethernet cable from
the wireless cameras to view
wirelessly via the Tuxedo Touch
Keypad. If the camera does not have
wireless capability, leave the
camera connected to router.
Camera Setup Icons
ADD
DISCOVER
Camera Icons
CAMERA
PLAY
SETUP
Camera Notes:
• To use the Pan/Tilt feature in Quad View, select the camera name from the camera list and then press Pan/Tilt.
• Press the Quad View icon to enter quad mode. Select a quadrant area on the screen (this area is highlighted) and then
select the camera that you want to appear in that quadrant.
• To remove a single camera, highlight the camera name and press DELETE. To remove all cameras, press DELETE ALL.
(Advanced Camera) Settings Press Save! after each selection. Note: Cameras must be enrolled to access the Settings
screen. If multiple cameras are enrolled, highlight the desired camera to make changes.
Video Settings: Select the following:
MPEG-4 Settings: Resolution, Fixed Quality and Max. Frame Rate
MJPEG Settings: Resolution, Fixed Video Quality and Max. Frame Rate
Network Settings: To make changes to the selected camera.
Internet Connection type: If set to Obtain an address automatically, selectable options are Enable Discovery for
UPNP, HTTP Port, RTSP Port. If set to Static IP, options are IP Address, Subnet Mask, Default Gateway, Enable
Discovery for UPNP, HTTP Port, RTSP Port.
Wireless: View the following settings: SSID, Security System, Passphrase/Shared Key, Network Type, Domain and
Channel Information.
Others: Reset to Defaults: a pop-up window displays: "Do you want to reset the Camera?" Select Yes to reset the
Restart Camera: Press to restart the camera.
Multi-Media (cont'd)
ACTION
DELETE
EDIT
QUAD
STOP AUTO
VIEW
PAN
camera to factory default settings.
The screen displays: "INFO: Camera wifi setup is
applicable only for discovered cameras"
Enter the appropriate wireless information.
SSID: ANY
Security Mode: Disabled, WPA personal, WPA2 personal, or
WEP.
Network Type: Infrastructure
Domain: USA
Channel: Auto
For Security Mode information enter:
Tx Key: 1, 2, 3 or 4.
WEP Encryption: 64 bit Key (10 Hex Chars) or 128 bit Key
(26 Hex Chars).
Authentication: Open System or Shared Key.
Passphrase; then press GO.
A pop-up window displays:
"Info XXX.XXX.X.X WIFI Configuration Saved"
DELETE ALL
SETTINGS
FULL
PAN/TILT
VIEW
20
NOTES
BACK
CAMERA WIFI
Add/ Edit Icons
SAVE
CONNECT RESET