Remove a Honeywell Thermostat
To remove a Honeywell Thermostat from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
b) Highlight the thermostat and press the
Z-Wave Remove/Delete icon.
2. At the thermostat:
a) Follow the instructions in the
thermostat Installation Guide under
"Installer setup" to "Remove a Z-Wave
Network Connection".
b) Once the exclusion process is complete,
press Done and the thermostat is
removed.
Remove All Z-Wave Devices
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the "Z-
Wave Device Management" screen.
b) Press the Z-Wave Reset icon to delete
all devices from the controller.
c) Select Yes or No.
Abort a Z-Wave Action
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the Z-
Wave Setup icon to display the "Z-Wave
Device Management" screen.
b) Press the Z-Wave Abort Operation icon
to abort that process.
Automation (cont'd)
ACTION
ACTION
ACTION
36
NOTES
Note: Honeywell is not responsible for property
damages due to improper setting of the thermostat
modes.
Z-Wave Remove/Delete -clears the node from
the keypad and resets device to the default
setting.
Notes:
• If the device is not removed, refer to the
"Z-Wave Troubleshooting" section.
• To remove a defective device, refer to the
"Z-Wave Troubleshooting" section.
NOTES
The message is displayed:
Window Warning
This Z-WAVE controller is about to be factory
defaulted and will lose all devices in the enrolled
list. All Z-WAVE devices must be re-enrolled
after this reset.
Yes or No
NOTES
If inadvertently a wrong process is selected, (i.e.,
add, delete, or remove failed device) press the
Z-Wave Abort icon to abort that process.