Camera Setup - Honeywell Tuxedo Touch WIFI Installation And Setup Manual

Camera Setup

The Camera feature allows you to enroll cameras and view up to four cameras at one time using the
quadrant view feature. If using existing (mounted) cameras, go to Step 4 below. If this is a first
time setup, scan/configure the cameras prior to mounting. View the "IP Camera Setup" training video
and then follow the steps below.
U L
Camera functionality is supplementary only and has not been evaluated by UL.
IMPORTANT: Use the web browser to view cameras for non-security purposes only. Camera streams
viewed from the web browser can stop without indication due to network connection issues.
ICON
1. Connect an Ethernet cable to the
back of your camera (LAN); connect
the opposite end to the Ethernet Port
on your router.
2. Apply power to the Camera. Wait a
few seconds for initial power-up of
camera.
3. Press the Multi-Media and Camera
icons (or press the Camera icon
from the "Home" screen) and then
press the Camera Setup icon.
4. Press the Discover icon to locate
cameras. The screen displays:
"Discovering Cameras Please Wait..."
5. Press the Add icon if the camera
information is not discovered
automatically, to enter information
on the "Add New Camera" screen.
6. To edit information, highlight the
camera name and press the Edit
icon. Highlight each field and enter
the required information, and then
press Save.
a) To retrieve camera settings and
connect to the camera, press the
Connect icon.
b) Press the Total Connect icon to
reset the camera for remote viewing
and activate a Total Connect
account. See section on "Remote
Services" later in this document.
c
) Press Save.
d) Use the Refresh icon to update the
screen.
Multi-Media (cont'd)
ACTION NOTES
Notes:
®
1. QuickTime media player must be installed on your PC.
2. Camera viewing is compatible with IE8 (and above) and
Safari 5.0 (and above); and not compatible with Opera web
browsers.
3. Do not use ports 6665-6669 for camera HTTP
configuration. These ports block MPEG streaming and PT
commands of Safari based PC and mobile devices.
Note: Some older versions of these cameras may need a
firmware upgrade; see separate instructions.
Use the Data Entry Keyboard to enter all required
information.
• Press the Up Arrow key to switch to upper case characters
• Press the X key to delete
• Press the ABC/.?123 key to switch between numerals and
symbols/characters.
• Press GO to return to previous screen.
Note: For best performance set video resolution to 320 x
240, 8 frames per sec, Normal quality.
Add/Edit Options:
Name: Enter a camera name.
Address: Enter IP or URL.
RTSP Port #: Select from (554, (1024-65534)).
Model: Select iPCAM-WI, iPCAM-WI2, iPCAM-WI2B (black),
iPCAM-WO or iPCAM-PT, WVC210, other.
User Name: Enter a user name, if desired.
Password: Enter a user password, if desired.
Resolution: Select from 160 x 120, 320 x 240 or 640 x 480.
Frame Rate: Select from 1, 2, 3, 4, 5, 6, 8, 10, 15, 20, 25, or
30.
*HTTP Port Number: Default value = 80. To change enter
valid port number (80 (1024-65534)).
A pop-up window displays:
"For remote camera viewing service, please contact your
alarm company and ask for Total Connect
provide the camera's MAC ID XX:XX:XX:XX:XX:XX. Press
continue to prepare the camera for Total Connect
service." Press CONTINUE or CANCEL. If you press
Continue a confirmation window displays: Do you want to
reset the Camera? Yes or No.
19
TM
service and