XYZ Printing Nobel 1.0 Product Manual page 14

● Error Code 2001: Resin bottle not found
Suggestion:
Make sure resin bottle is placed correctly and NFC tag is in place under the bottle.
If the NFC label is missing, please contact customer service center.
● Error Code 2002: UV laser module not calibrated
Suggestion:
Contact customer service center directly.
● Error Code 2003: Resin bottle empty
Suggestion:
Resin bottle is empty is based on the the reading from the NFC tag. Select "INFO">"RESIN STATUS" to check resin level. When
"REMAINING" is shown as "0%", then the resin bottle should be empty. Please install another XYZprinting resin bottle
before printing.
● Error Code 2004: Lid not covered during printing
Suggestion:
Place the lid on the printer before printing. If the lid is placed correctly, please
remove the lid, select "INFO">"SENSOR STATUS", tap the lid sensor and see if the
status of "C" switches from 0 to 1. If the value doesn't switch accordingly, then the
sensor is malfunctioning.
Contact the service center after you have checked the status of the printer.
● Error Code 2005: Unrecognized resin tag
Suggestion:
Check the record of the resin bottle by selecting "INFO">"RESIN STATUS". If the display shows "UNIDENTIFIED TAG", please
change to XYZprinting resin bottle.
● Error Code 2006: Unsupported file format
Suggestion:
"Print from USB" supports only .3w/.3wn format. Please select files in the supported format.
● Error Code 2007: File too large
Suggestion:
Please select a .3w/.3wn file, size no more than 200MB.
● Error Code 2020: Printer is busy
Suggestion:
Wait until the printer finishes current task. If the error persists when the printer is idle, please try to restart the printer.
-14-
V1.5