XYZ Printing Nobel 1.0 Product Manual page 6

MOVE PLATFORM
Activate the function when you need to move the platform manually.
Simple select move the platform "to top" or "to bottom" to proceed:
MOVE PLATFORM
TO TOP
►TO BOTTOM
SETTINGS
The Settings menu alows you to adjust printer settings.
BUZZER
When the buzzer is turned on, the printer will output an audible signal when a button is pressed, print job is finished,
or issue is detected.
Buzzer is turned on by default. To switch off the buzzer:
BUZZER
►OFF
ON
Select "OFF" and press [OK] to change the setting.
AUTO-FILL
When "Auto Fill" is enabled, the printer will fill the resin tank before printing and when low tank level is detected.
With the auto-fill function, you no longer need to manually refill the resin during printing. This is especially useful
when printing large objects.
"Auto Fill" is enabled by default. To disable the function:
AUTO FILL
►OFF
ON
Select "OFF" and press [OK] to change the setting.
Note • Be sure to place the printer on a leveled surface, or tank level detection may be inaccurate.
• Auto-fill will be switched off when the timeout expires. Timeout may be caused by an empty resin bottle
or the tank level sensor soaked by resin. Please replace the resin bottle or clean up the level sensor before
enabling the function.
LANGUAGE
You may switch the display language on the printer.
The default lanague is English. To switch to other language:
LANGUAGE
ENGLISH
►ニホンゴ
FRANCAIS
Select a language and press [OK] to change the setting.
MOVE PLATFORM
TO BOTTOM NOW?
NO
►YES
[ON]
[ON]
[EN]
TASK COMPLETE
[OK] TO FINISH
-6-
V1.5