Lower the table down far enough so that you can
easily attach the AABS. Power off the VersaLASER.
By hand, move the X‐axis arm and Focus Carriage
to a comfortable working position in the field.
Remove (if present) the plug (1) with a
screwdriver. Attach the mounting block (2), if not
already attached, with the 4‐40 screw and using a
3/32 Allen wrench.
Using a 3/16 socket tool or 5mm wrench, attach
the needle valve (1) to the port where you
removed the plug. Be careful not to cross‐thread
the small device when installing and do not over
tighten it. Attach the AABS (2) to the mounting
block using the thumbscrew (3) and making sure
that it is adjusted so that it is as high up (4) as
possible.