ULS VersaLaser VL-200 Safety & Installation Instructions page 57

Graphics Setup
Open your graphics software. In this case we will use
CorelDRAW12 and create a new graphic.
Using the Transformations menu, rotate your graphic
90 degrees to the right to match the glasses
orientation. Reposition your graphic so that its RIGHT
CENTER anchor point, which was the TOP CENTER
before we rotated it 90 degrees, is located at the
same X‐axis coordinate as the Red Dot pointer. The
vertical placement of where you position your graphic within your graphic software is irrelevant because
the VCP will automatically match the vertical center of the graphic with the mark you placed on the
glass. Just make sure that the graphic is positioned within the printable page area.