fumes for several minutes after laser processing and may pose a health hazard. Avoid using this
device in small, enclosed, or non‐ventilated areas.
Some materials, during and after laser processing, may produce corrosive fumes. DISCONTINUE
processing any material that produces signs of chemical deterioration in the laser system such as
rust, metal etching or pitting, peeling paint, etc. Damage to the laser system from corrosive
materials is NOT covered under warranty.
Care should be taken when moving or lifting this device. Obtain assistance from 1 or 2 additional
people when lifting or carrying (secure motion system and access door). Severe bodily injury may
occur if improper lifting techniques are applied or the system is dropped.
Dangerous voltages are present within the electronics and laser enclosures of this system.
Although access to these areas is not necessary during normal use, if it becomes necessary to open
one of these enclosures for service reasons, please remember to disconnect the power cord from
your electrical supply.
This device is specifically designed to comply with CDRH performance requirements under 21 CFR
1040.10 and 1040.11. CDRH is the Center for the Devices of Radiological Health division of the Food
and Drug Administration (FDA) in the USA. It also complies with CE (European Community) safety
regulations. No guarantees of suitability or safety are provided for any use other than those
specified by Universal Laser Systems, Inc.