Push down on the release lever of the fitting on
the back of the VersaLASER until it "clicks" (1).
Insert one end of the blue hose into the fitting
until it also "clicks".
NOTE: Before continuing, you MUST have completed Section 2 of this manual which includes
connecting the USB cable and power cord to the VersaLASER and loading the VersaLASER Installation
Software. If not, go back to that section, complete the installation, and return here.
Make sure you computer is powered on and booted into Windows.
Connect a 3 ft. USB cable between the VersaLASER's USB port #3 and the USB port located towards
the bottom of the CCCAU. NOTE: Windows will indicate to you that it has recognized the device by
powering it on for about 5 seconds and then automatically turning it off. Once this occurs, it is
ready for use. If Windows does not recognize the device it will prompt you for the device driver
disk again. Insert your VersaLASER Installation CD‐ROM and follow the on‐screen instructions.
Connect the other end of the blue hose to the Air
Compressor (1) in the same fashion. Plug in a
power cord from your power source to the power
inlet (3) of the CCCAU.