ULS VersaLaser VL-200 Safety & Installation Instructions page 52

User door

Every 8 hours of processing
Clean X‐axis bearings and bearing tracks
Check Beam window, #2 Mirror, #3 Mirror, and Focus Lens for debris. Clean ONLY if dirty.

Every month
Clean side and rear cooling fan filters

Every 6 months
Exhaust plenum
If you are noticing a considerable buildup of debris on the optics and the motion system, clean the system
at more frequent intervals. If your system has remained relatively clean, you can extend your cleaning
intervals. Keep in mind that a clean machine is a better performing machine and can extend the life of
the parts as well as reduce the possibility of down time. If you have any questions about maintaining the
laser system, please contact our Customer Support Department.
Section 5
Accessories
As an addition to the regular VersaLASER, we offer a wide variety of optional accessories. Before
attempting to use any of the accessories in this section, make sure that you are comfortable operating
the VersaLASER, the VCP, and your graphics software.