ULS VersaLaser VL-200 Safety & Installation Instructions page 36

sharpen the resulting image. Do not change this number unless instructed to do so by our customer
support department.

The LENS SIZE choice from the dropdown list should be the same as the number printed on the lens
assembly on the side of your VersaLASER's Focus Carriage. If you change lenses (available
accessory) other than the standard 2.0, then you MUST select the value that matches your installed
lens otherwise your VersaLASER will not focus the laser beam properly.
FOCUS

Manually positions the Focus Carriage to an absolute position in the field to either manually focus
the laser beam to the surface of your material, instead of using the Autofocus feature, or to locate
an absolute position within the table area by using the Red Dot pointer. To illuminate the Red Dot
pointer, simply open the user door. Using your mouse, position the on‐screen crosshairs to the
desired position, indicated by the X‐axis (left) and Y‐axis (right) coordinates next to the crosshair,
and left‐clicking once. The Focus Carriage will then move to that position. Or, you can accomplish
the same thing by typing in the X‐axis and Y‐axis coordinates of the location you desire in the X‐axis
and Y‐axis boxes at the bottom left of the screen and left‐clicking the "MOVE" button.