and click Print. As usual, the print job will be stored on your hard disk and become available in the VCP
as the next job ready to be processed. The VersaLASER automatically knows that the VCA is installed
and it will automatically compensate for the focus height difference. Place your material directly on the
VCA and proceed to cut.
Note: You may experience a slight "notching effect" on the backside edge of the material. This is due
to the reflectivity of the honeycomb material and is normal. To reduce the effect, try reducing the
Intensity setting. To completely eliminate the effect, you may want to elevate you material off of the
honeycomb by using some sort of spacers, at least 1/8th to 1/4 inch thick, between the honeycomb
surface and your material that does not interfere with the beam path. If you are to do this, be sure to
select Custom for the Fixture type and enter the thickness of your spacer in the Height box.