Inside the VersaLASER you will find the large
recessed slot with a self‐aligning electrical
connector to the right side (1) and the two
alignment pins (2).
Graphics Setup
Open your graphics software. In this case we will use CorelDRAW11 and create a new graphic. Layout
your graphic the same way as if the regular table is installed.
The border of the honeycomb material of the VCA is slightly larger than the printable area of the
VersaLASER. Since there are no reference rulers attached to the table, if you desire, you can use the Red
Dot pointer as your positioning reference.
Printing
Print as normal. When the VersaLASER Settings dialog
box pops up, choose your category and type of
material as usual. In the Fixture section, select NONE
from the dropdown list. Using a caliper or similar
measuring device, measure the thickness of your
material and enter it into the Material Thickness box
By using the thumbscrews as handles (3), insert
the VCA into the slot (it is OK to do with the
power on because it is hot swappable) and move
it around until the connector engages and the
fixture sits flat.