On the underside of the CORA notice the self-
aligning electrical connector (1) and two alignment
holes (2).
Basic Operation
In this example, we are going to etch a simple drinking glass.
Before loading the glass into the fixture, using a Using a caliper or similar measuring device,
Insert the CORA into the slot (OK to do with the
power on because it is hot swappable) and move
it around until the connector engages, the pins
protrude through the alignment holes, and the
fixture sits flat. It will indicate that it is installed
properly by automatically rotating its cone
slightly and a Rotary button will appear in the
Focus tab of the VCP.