ULS VersaLaser VL-200 Safety & Installation Instructions page 59

Installation
Lower the table all the way down to the bottom of its travel or down far enough so that you can remove
the table and install the VCA without interfering with the moving parts of the VersaLASER.
Remove the table by loosening
the two captive thumbscrews
(1). Insert your fingers into the
two holes (2) and slowly lift the
table out of the VersaLASER
being careful not to bump it
around. On the underside of
the VCA find the self‐aligning
electrical connector (3) and
two alignment holes (4).