6.7 Adjusting the Footrest (Fig. 68-69)
6�7�1 Adjusting the footrest Height Avantgarde T /Ti 8�9/Ti Ultra (Fig. 68)
By loosening the screw at the footrest bar (Fig. 68), the footplate can be continuously adapted
to your lower leg length and to the thickness of your seat cushion.
Loosen the screw – do not completely remove the screw. There are two threaded
INfORMATION
holes in the footrest bar. Depending on the desired adjustment, however, it may be necessary
to completely remove the screw and use the second hole.
Make sure to firmly retighten all screws and nuts after making adjustments. The torque
INfORMATION
for the cap screws is 10 Nm.
6�7�2 Adjusting the footrest Height Avantgarde VR and XXL 2 (Fig. 69)
By loosening the screw (Fig. 69, item A), the footplate can be adapted to your lower leg length
and to the thickness of your seat cushion.
Make sure when adjusting the footrest height, that the footrest bar (Fig. 69, item A) is slid into
the swivel segment (Fig. 69, item C) at least 60 mm.
Make sure to firmly retighten all screws and nuts after making adjustments. The torque
INfORMATION
for the screw (Fig. 69, item A) is 8 Nm.
86
66
68
67
C
A
B
69