Licence Plate Light; Bulb Replacement - Triumph Speed Triple Handbook

Maintenance and Adjustment

Licence Plate Light

Bulb Replacement

Remove the front panel from the fuel tank.
Disconnect the battery, negative (black) lead
first.
Caution
Do not pull the licence plate bracket more
than is necessary to access the light's inside
fixing nut. Damage to the bracket will
result from pulling it too far.
Remove the fixings for both rear indicators.
2
1
1. Fixing, left hand side shown
2. Licence plate bracket
Carefully raise the licence plate bracket to
gain access to the locknut.
Counter-hold the locknut to prevent it from
turning and remove the licence plate light
fixing. Collect the locknut.
Detach the light from the bracket. It is not
necessary to disconnect
connectors.
120
To avoid cable damage, do not pull the
bulb holder using the cables. Pull only on
the bulb holder.
Carefully remove the bulb holder from the
back of the light unit. Remove the bulb.
1. Licence plate light
2. Bulb holder
Installation is the reverse of the removal
procedure, noting the following:
Tighten the lamp fixing to 2 Nm.
Tighten the rear indicator fixings to 3 Nm.
Reconnect the battery, positive (red) lead first.
Refit the front panel and tighten the side
fixings to 3 Nm.
the electrical
Caution
1
2