Usb Configuration; Redirection After Bios Post [Always]; Terminal Type [Ansi] - Pixelink PPC15-CX Instruction Manual

PPCxx-CX Series Flat Panel PC
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave

Redirection After BIOS POST [Always]

Use the Redirection After BIOS POST option to specify when console redirection should
occur.
Disabled
Boot Loader
Always

Terminal Type [ANSI]

Use the Terminal Type BIOS option to specify the remote terminal type.
ANSI
VT100
VT-UTF8

5.3.7 USB Configuration

Use the USB Configuration menu (BIOS Menu 10) to read USB configuration
information and configure the USB settings.
The console is not redirected after POST
Redirection is active during POST and during Boot
Loader
Redirection is always active (Some OSes may not
D
EFAULT
work if set to Always)
The target terminal type is ANSI
D
EFAULT
The target terminal type is VT100
The target terminal type is VT-UTF8
Page 91