At/Atx Mode Selection; Figure 3-9: Ppc-Cx Hdd Retention Screws - Pixelink PPC15-CX Instruction Manual

3-9).

Figure 3-9: PPC-CX HDD Retention Screws

Connect the SATA/IDE cable to the rear of HDD.
Step 5:
Install the HDD into the panel PC by aligning the retention screw holes in the
Step 6:
HDD brackets with the retention screw holes on the chassis. Insert the four
retention screws.
Replace the aluminum back cover to the chassis.
Step 7:
Replace the plastic back cover.
Step 8:

3.7 AT/ATX Mode Selection

AT and ATX power modes can both be used on the PPC series. The selection is made
through an AT/ATX switch on the aluminum chassis inside the plastic back cover (Figure
3-10). To select AT mode or ATX mode, follow the steps below.
Remove the plastic back cover. See Section 3.5 above.
Step 1:
Locate the AT/ATX switch on the aluminum chassis (Figure 3-10).
Step 2:
Page 50
PPCxx-CX Series Flat Panel PC
Step 0: