Gently pull the spring retainer clips of the SO-DIMM socket out and push the
Step 8:
rear of the DDR2 memory module down (Figure 4-5).
Release the spring retainer clips on the SO-DIMM socket. They clip into place
Step 9:
and secure the DDR2 memory module in the socket.
Figure 4-5: DDR2 SO-DIMM Module Installation
Re-insert the thermal pad into the memory module.
Step 10:
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of
two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Page 66
PPCxx-CX Series Flat Panel PC
Step 0:
Jumper