Serial Device Connection; Figure 3-16: Serial Device Connector - Pixelink PPC15-CX Instruction Manual

3.9.2 Serial Device Connection

The PPC Series has two single female DB-9 connectors on the bottom panel for a serial
device. Follow the steps below to connect a serial device to the PPC Series panel PC.
Locate the DB-9 connector. The location of the DB-9 connector is shown in
Step 1:
Chapter 2.
Insert the serial connector. Insert the DB-9 connector of a serial device into
Step 2:
the DB-9 connector on the bottom panel. See Figure 3-16.

Figure 3-16: Serial Device Connector

Secure the connector. Secure the serial device connector to the external
Step 3:
interface by tightening the two retention screws on either side of the connector.
Page 58
PPCxx-CX Series Flat Panel PC
Step 0: