Installation And Configuration Steps; Unpacking - Pixelink PPC15-CX Instruction Manual

PPCxx-CX Series Flat Panel PC

3.3 Installation and Configuration Steps

The following installation steps must be followed.
Unpack the flat panel PC
Step 1:
Install CF card
Step 2:
Install HDD
Step 3:
Mount the flat panel PC
Step 4:
Connect peripheral devices to the bottom panel of the flat panel PC
Step 5:
Configure the
Step 6:

3.4 Unpacking

To unpack the flat panel PC, follow the steps below:
WARNING!
The front of the LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the flat panel PC has been
properly installed. This ensures the screen is protected during the
installation process.
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
Step 1:
external box.
Open the external box.
Step 2:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
Step 3:
internal box.
Lift the monitor out of the boxes.
Step 4:
Remove both polystyrene ends, one from each side.
Step 5:
systemStep 0:
Page 43