Table of Contents
Advertisement
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 100mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the PPC series flat panel PC.
Once the mounting arm has been firmly attached to the surface, lift the PPC
Step 2:
onto the interface pad of the mounting arm.
Align the retention screw holes on the mounting arm interface with those in the
Step 3:
PPC. The PPC-CX arm mount retention screw holes are shown in Figure 3-14.
Figure 3-14: PPC-CX Arm Mounting Retention Screw Holes
Secure the PPC to the interface pad by inserting four retention screws through
Step 4:
the bottom of the mounting arm interface pad and into the PPC.
Page 56
PPCxx-CX Series Flat Panel PC
Step 0:
Advertisement
Chapters
Table of Contents
