Grizzly G1014Z Owner's Manual page 39

9.
adjust the front of the work table
from the sanding belt (see figure 68) across
its entire length.
figure 68. Correct distance between work table
and sanding belt.
—if the gap is not ⁄
1
of the work table, loosen one or both of the
screws under the table (see figure 69),
where the arm is attached to the table, and
adjust the table untll the distance is correct,
then tighten the screws.
mounting
screws
arm
table tilt
Knob
figure 69. location of work table arm mounting
screws.
Note: To reduce the chance of vibration or
rattling sounds, make sure the table support
rod does not touch the motor.
10. tighten the mounting bracket set screws to
secure the support rod.
model g1014z/g1014zX (mfg. 11/07+)
⁄ " away
1
16
⁄ "
1
16
gap
" across the entire length
16
angle
pointer
11. place a machinist's square on the work table
and against the sanding belt, as shown in
figure 70, and check for gaps between the
square, belt, and table.
figure 70. squaring table and sanding belt.
—if there are any gaps, loosen the table tilt
knob, adjust the table as needed to remove
the gaps, then tighten the knob. loosen the
angle pointer screw, position the pointer
over the zero mark on the scale, then
tighten the screw.
12. use a fine ruler or combination square to
check if the distance from the slot to the belt
is the same at both edges of the belt.
figure 71. Checking miter slot-belt distance.
—if the distance is the same, no adjustments
need to be made.
-37-