Grizzly G1014Z Owner's Manual page 22

3.
Fasten a long upper and long lower brace
to the two stand legs with (8)
carriage bolts, ⁄ "-18 hex nuts, and
5
16
washers, as shown in figure 16. Finger
tighten the fasteners for now.
Note: Make sure the lip on the long braces
faces up.
leg
lip
long upper Brace
figure 16. stand legs fastened to long braces.
4. repeat Step 3 to fasten the two remaining
long upper and long lower braces to the
remaining stand legs.
5.
Fasten the two short upper braces and the
two short lower braces to one of the leg
assemblies with the (8)
bolts, ⁄ "-18 hex nuts, and
5
16
as shown in figure 17.
short lower
Brace
short
upper
Braces
figure 17. short upper and lower braces
fastened to leg assembly.
-20-
5 ⁄ "-18 x 1 ⁄ "
16 2
⁄ " flat
5
16
long lower Brace
x8
⁄ "-18 x ⁄ " carriage
5 1
16 2
⁄ " flat washers,
5
16
x8
make sure the two short upper braces overlap
the long upper braces and that the braces are
placed inside the leg assemblies, as shown in
figure 18.
short upper Brace
long upper Brace
figure 18. short brace overlapping long upper
brace.
6.
Fasten the second leg assembly to the brac-
es on the first leg assembly with the remain-
ing (8) ⁄ "-18 x ⁄ " carriage bolts,
5 1
16 2
nuts, and ⁄ " flat washers, then place the
5
16
stand upright on its feet, as shown in figure
19.
figure 19. stand assembled.
7.
Final tighten all the fasteners on the stand.
8.
tighten the lock nuts on the feet.
model g1014z/g1014zX (mfg. 11/07+)
area of overlap
⁄ "-18 hex
5
16