Grizzly G1014Z Owner's Manual page 24

2.
secure the sanding unit to the stand or cabi-
net with the (4) 5 ⁄ "-18 hex bolts and
16
washers, as shown in figures 23 & 24.
figure 23. g1014z sander fastened to stand
(view from underneath stand).
x4
figure 24. g1014zX sander fastened to cabinet
(two of four hex bolts shown).
3.
slide the flat ends of the idler roller into
the slots on the roller adjustment bars (see
figure 25).
figure 25. idler roller installed.
-22-
5 ⁄ " flat
16
x4
idler roller
4.
use the 4mm hex wrench to back the shaft
set screws on the cast iron plate out of the
shaft hole and keyway (figure 26).
set screws
figure 26. set screw locations on sanding disc
plate.
5. align the keyway on the plate with the drive
shaft key, then slide the plate onto the shaft,
as shown in figure 27.
figure 27. installing plate onto drive shaft.
6.
adjust the cast iron plate so it protrudes slight-
ly ( ⁄ "- ⁄ ") beyond the curved lip of the metal
1 1
16 8
cover on both sides, as illustrated in figure
28, to avoid the possibility of workpieces hit-
ting the cover during sanding operations.
figure 28. gap between plate and cover.
model g1014z/g1014zX (mfg. 11/07+)
Key