18. install the 2" dust port onto the back of the
sanding belt frame with the pre-installed
20 x
⁄
" hex bolts and flat washers, as shown
1
2
in figure 36.
figure 36. 2" dust port installed.
19. assemble the quick release lever, as shown
in figure 37, using the handle, 6" quick
release lever stud, short lever arm, and
hex nuts, thread the assembly into the rocker
arm, then tighten the hex nuts.
hex nuts
rocker
short
arm
lever
arm
figure 37. Quick release lever installed.
20. move the quick release lever toward the
motor, slide the sanding belt over the lever
and onto the idler roller and drive rollers,
then center the belt on the rollers (see figure
38).
model g1014z/g1014zX (mfg. 11/07+)
1
⁄
"-
4
2" dust
port
⁄
"-16
3
8
6" stud
handle
idler
roller
figure 38. Belt installed onto idler and drive
rollers.
21. push the lever toward the motor to tension
the sanding belt.
22. loosen the thumb knobs behind the idler
roller, and install the idler roller assembly
(figure 39).
thumb Knob
figure 39. idler roller guard installed.
drive roller
idler roller guard
-25-