Troubleshooting - Swisscom Aton CL120-CLT120 Operating Instructions Manual

Useful Information
Display message
Speicher voll
Akkus
benutzen
Bitte die
Rufnr. Anzeige
bestellen !
*1 "BS" in display message represents base unit.

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor and turn off the handset, then reconnect the base unit's AC adaptor and turn on the
handset.
General use
Problem
The handset does not turn
on even after installing
charged batteries.
The unit does not work.
The handset display is
blank or dark.
48
ATON_CL120_CLT120(en-de)_0722_ve48
Cause/solution
R The phonebook memory is full. Erase unwanted entries
(page 20).
R Message memory is full. Erase unwanted messages
(page 39, 40).
R The call block list memory is full. Erase unwanted entries
(page 31).
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 7.
R Once you receive caller information this message will not be
displayed.
Cause/solution
R Place the handset on the base unit or charger to turn on the
handset.
R Make sure the batteries are installed correctly (page 9).
R Fully charge the batteries (page 9).
R Check the connections (page 9).
R Unplug the base unit's AC adaptor to reset the unit and turn off
the handset. Reconnect the adaptor, turn on the handset and
try again.
R The handset has not been registered to the base unit. Register
the handset (page 34).
R The handset is in screen saver mode (page 15). Activate the
handset display again by:
– pressing M N when on a call.
– pressing M N at all other times.
R "Licht bei Laden" is set to "Aus" while on charge.
Change the setting (page 27).
R The handset is not turned on. Turn the power on (page 13).
48 2014/07/22 15:07:48