Do Not Disturb Mode; Nuisance Call Block - Swisscom Aton CL120-CLT120 Operating Instructions Manual

Programming

Do not disturb mode

Do not disturb mode allows you to select a
period of time during which the handset will
not ring for outside calls. This feature is useful
for time periods when you do not want to be
disturbed, for example, while sleeping. Do not
disturb mode can be set for each handset.
Using the phonebook's category feature
(page 19), you can also select categories of
callers whose calls override do not disturb
mode and ring the handset.
Important:
R Make sure the unit's date and time setting
is correct (page 14).
R We recommend turning the base unit ringer
off (page 25) in addition to turning do not
disturb mode on. (Aton CLT120 series:
page 3)
R If you have set the alarm, the alarm sounds
even if do not disturb mode is turned on.
Turning do not disturb mode on/off
1
M N (right soft key) #238
2
MbN: Select the desired setting. a MOKN
R If you select "Aus", press M
3
Enter the desired hour and minute you
wish to start this feature. a MOKN
4
Enter the desired hour and minute you
wish to end this feature. a MOKN a
M N
Changing the start and end time
1
M N (right soft key) #237
2
Continue from step 3, "Turning do not
disturb mode on/off", page 30.
Setting the ring delay
This setting allows the handset to ring during
do not disturb mode if the caller waits long
enough. After the selected amount of time
passes, the handset rings. If you select "Kein
Rufsign.", the handset never rings during
do not disturb mode.
1
M N (right soft key) #239
30
ATON_CL120_CLT120(en-de)_0722_ve30
2
MbN: Select the desired setting. a MOKN
a M
Note:
R When the answering system answers the
call, this feature does not work. (Aton
CLT120 series: page 3)
Selecting categories to bypass do
not disturb mode
1
M
2
Select your desired categories by
pressing 1 to 9.
R " " is displayed next to the selected
category numbers.
R To cancel a selected category, press
the same dial key again. " "
disappears.
3
MOKN a M

Nuisance call block

This feature rejects calls from unwanted
callers. The following items are available when
storing phone numbers in the call block list (50
N to exit.
max.).
– "Einzelne Nummer": The unit can reject
calls from specific phone numbers.
– "Nummernkreise": The unit can reject
calls that begin with a number stored in the
call block list, such as a toll-free phone
number prefix or certain area codes.
You can also set the unit to reject calls that do
not have a phone number.
When a call is received, the unit does not ring
while the caller is being identified. If the
caller's phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call.
Important:
R Rejected calls are logged in the caller list.
30
N
N (right soft key) #241
N
2014/07/22 15:07:47