Caller Id Service; Using Caller Id Service; Caller List; Missed Calls - Swisscom Aton CL120-CLT120 Operating Instructions Manual

Caller ID Service

Using Caller ID service

Caller ID features
Note:
R In the Swisscom network CLIP is
transmitted automatically.
When an outside call is being received, the
caller information is displayed.
Caller information for the last 50 callers is
logged in the caller list from the most recent
call to the oldest.
R If the unit cannot receive caller information,
the following is displayed:
– "Dienst nicht vorh.": The caller
dials from an area which does not
provide a Caller ID service.
– "Nummer unterdr.": The caller
requests not to send caller information.
R If the unit is connected to a PBX system,
caller information may not be properly
received. Contact your PBX supplier.

Missed calls

If a call is not answered, the unit treats it as a
missed call and is displayed. This lets you
know if you should view the caller list to see
who called while you were away.
Even if only one missed call in the caller list is
viewed (page 36), disappears from the
display. When you receive another new call,
is displayed again.
Note:
R Even when there are unviewed missed
calls, disappears from the standby
display if the following operation is
performed by one of the registered
handsets:
– Being replaced on the base unit or
charger.
– Pressing M N.
Phonebook name display
When caller information is received and it
matches a phone number stored in the
phonebook, the stored name in the
36
ATON_CL120_CLT120(en-de)_0722_ve36
phonebook is displayed and logged in the

caller list.

Caller list
Important:
R Make sure the unit's date and time setting
is correct (page 14).
Viewing the caller list and calling
back
1
M N
2
Press MCN to search from the most recent
call, or press MDN to search from the
oldest call.
3
To call back, press M
To exit, press M
Note:
R In step 2, to see the detailed information
when in multiple display mode:
M N a MbN: "Detail" a MOKN
R If the entry has already been viewed or
answered, " " is displayed.
Using the Smart-Taste
When
flashes slowly, there are missed calls.
Press M
list and calling back", page 36.
R "Entgangener Anruf" must be set to
"On" in "Setting the Smart-Taste", page 14.
R If the handset is placed on the base unit or
charger, you need to lift up the handset to
view the caller list after pressing M
R When the unit has new messages
missed calls, the unit can be operated to
play the new messages first and then show
the missed calls.
*1 Aton CLT120 series: page 3
Editing a caller's phone number
1
M N
36
N.
N.
is displayed and the indicator
N in step 1 on "Viewing the caller
2014/07/22 15:07:47
N.
*1
and