General Information; Automatic Power Off - Hitachi SF-P90P User Manual

Fully automatic
Table of Contents

Advertisement

General Information

一般資料
Phenomenon
• When the washing machine is used for the fi rst time, water
may fl ow out of the drain hose.
• 首次使用洗衣機時,可能有水從排水管流出。
• When the water supply hose is set and the water tap is
opened, a slight amount of water may come out of water
supply inlet.
• 安裝好供水管,開啟水龍頭時,可能會有少許水從供水口流出。
• The remaining time increases or decreases.
• 剩餘時間增加或減少。
• Water is supplied during washing.
• 洗衣期間有水供應。
• When the reserved operation is in progress, the operation
does not come to an end even after the preset time elapsed.
• 當預定操作進行中,即使預設時間已過,操作也不結束。
• Spinning stops and water is supplied at the time of spinning
before rinsing.
• 脫水停止,並在沖洗前的脫水過程中供水。
• Spinning stops during last spinning cycle and reverse back to
rinse with water fi lling in.
• 在最後脫水程式時停止轉動,返回沖洗程式,用注入的水沖洗。
• Spinning cycle takes place intermittently.
• 脫水程式間歇性地進行。
• When the tub is moved by hand, a splashing sound can be
heard.
• 用手移動洗衣筒時,可聽到飛濺聲。
• When the
NORMAL
course is in operation, spinning rinse
"
"
cycle with water injection is not performed.
• 當「標準」程式運作時,不會進行「沖洗程式時噴水並旋轉」。

Automatic power OFF

1. When the operation fi nishes, power is automatically turned off.
2. Power is automatically cut off if the following situation remains for over an
hour.
& Pause mode.
' Lid is left opened during spin cycle.
( Abnormal alterations as described on page
3. When START button is not pressed within 5 minutes after machine is being
turned on, power is automatically cut off.
現象
42.
Causes
• This is the water which remains after the performance test is
conducted at factory.
• 這是工廠進行性能測試後剩下的水。
• It takes a while to close the special water hammer noise
reducing valve assembly.
• 關閉減少水錘噪音的特別閥門組裝需要一段時間。
• The remaining time is corrected depending on the time of
water supply and drainage.
• 剩餘時間會根據供水和排水時間作出修正。
• When the water level decreases during washing, water is
automatically supplied.
• 當洗衣過程中水位下降時,會自動供水。
• If amount of washing water is in a short supply, the washer
may continue functioning even after the preset time elapsed.
• 供水量短缺時,即使預設時間已過,洗衣機仍可能繼續運作。
• The safety switch has functioned because the clothes have
moved to one side.
• 由於衣物側在一邊,安全開關啟動了。
• This takes place when the safety switch is activated as a
result of an uneven distribution of laundry. When water fi ll in
and pulsator rotates, laundry can be balanced by the motion
and spin cycle will resume.
• 這是由於衣物的不平均分佈啟動了安全開關。當水注入時,攪
拌翼旋轉,衣物便可平衡分佈,脫水程式便會繼續。
• The number of spinning rotations is controlled by the rotation
sensor in order to perform an effective spin-drying operation.
• 脫水旋轉次數由旋轉感應器抵制,以確保脫水乾衣運作有效。
• This is the sound of water in the fl uid balance that eliminates
vibration during spinning.
• 這是消除脫水震動的液體平衡器的水流聲音。
• The safety switch has been activated because the load is off-
balance in the tub.
• 由於洗衣筒內的衣物分佈不平均,導致安全開關啟動。
自動關閉電源
1. 運作完成後,電源自動關閉。
2. 如以下情況持續超過一小時,電源將自動中斷。
& 暫停模式。
( 如第
3. 如洗衣機開啟電源後 5 分鐘內沒有按下啟動按
鈕,電源將自動中斷。
原因
' 脫水程式時打開機蓋。
42 頁所述的異常情況。
43

Advertisement

Table of Contents
loading

Table of Contents