Alarm Mode Indicators 警報指示燈 - Hitachi SF-P90P User Manual

Alarm Mode Indicators
Before requesting repair, check the following points one more time.
在要求維修前，請再一次檢查下列各點。
• Abnormality alarm: When the following cases occur, you will be alert by fl ashes of indicators and sound of buzzer.
• 異常警報：如發生以下情況，指示燈將會閃爍，蜂鳴器亦會作響以給予您警示。
Symptoms Indicator fl ashes
徵兆 指示燈閃爍
Not running
不運作
Not fi lling in water
不注滿水
(Not fi lled with water after
60 minutes)
（60 分鐘後沒有注滿水）
Not draining
不排水
(Drainage isn't completed
within 20 minutes)
（20 分鐘內仍未完成排水）
Not spinning
不脫水
Cannot lock the lid
(The lid is unproperly
closed.)
無法鎖緊機蓋
（機蓋沒有妥善關閉。 ）
Cannot unlock the lid
無法解鎖機蓋
The spinning speed
is not reached the
specifi ed value.
轉動速度未達到指定值。
•
• 如有顯示警告信號（例如「F0」、「F9」），請立即停止洗衣機運作，並聯絡授權服務經銷商或代理商進行進一步檢查及 或維修。
42
警報指示燈
• Check if electricity is cut off?
• Check if fuse or circuit break is blown?
• Check if power cord is properly plugged?
• 檢查是否停電？
• 檢查保險絲或斷路器是否燒斷？
• 檢查電源線是否妥善地插入插座？
• Is the water tap turned off?
• Is city water frozen or water supply stopped?
• Does dust clog the screen in the water supply inlet?
• 水龍頭是否關上了？
• 供水是否結冰或是否停水？
• 供水口濾網是否被塵埃阻塞？
• Check if drain hose is completely released?
• Check if drain hose is damaged?
• Check if drain opening is immersed in water?
• Check if drain hose is obstructed?
• Check if the interior of the drain hose is frozen?
• 檢查排水管是否完全放下？
• 檢查排水管是否損壞？
• 檢查排水口是否浸在水裏？
• 檢查排水管是否被阻塞？
• 檢查排水管內部是否結冰了？
• Is the lid opened?
• 機蓋是否打開了？
• Are clothes inclined to one side?
• 衣物是否側於一邊？
• Does the lock hole of lid match with the pin of
interlock switch?
• 機蓋的鎖孔是否對準互鎖開關的扣？
• Is there something that remains inside of the hole?
(dust, lint etc.)
• 孔內是否有物件殘留？（塵埃、棉絮等等）
• Check if the amount of powder detergent is too
much?
• Check if the drain hose is clogged?
• Check if the drain hose is bend up more than 10
cm.?
• Check if the drain hose has been connected until it is
more than 2 meter?
• 檢查洗衣粉份量是否太多？
• 檢查排水管是否被堵塞了？
• 檢查排水管是否彎起多於 10
• 檢查排水管是否連接至 2 米以上？
Check items
檢查項目
厘米 ？
Restart
重新啟動
• Make sure power is on.
• Make sure the power cord is properly
plugged.
• 確保電源開啟。
• 確保電源線是否妥善地插入插座。
• Press the START/PAUSE button and
eliminate the cause of the trouble.
• 按下啟動 暫停按鈕，解決問題成因。
• Close the lid.
• 關閉機蓋。
• Wait until the tub stop spinning, press
START/PAUSE to unlock and open the
lid then balance the clothes in the tub.
Close the lid and press START/PAUSE
to restart.
• 等待洗衣筒停止轉動。按下啟動 暫停
按鈕以解鎖並開啟機蓋，然後把衣物放
至平整。關閉機蓋，按下啟動 暫停按
鈕以重新啟動。
• Close the lid correctly
• 正確地關閉機蓋
Restart
重新啟動
• If "C9" keeps ashing, please request
repairing.
• 如「C9」繼續閃爍，請要求維修服務。
• After correcting the problems, once
turn off the machine and turn on again.
Select NORMAL course and operate for
1 cycle without adding detergent.
• For drain hose connection, refer to the
Instruction Manual.
• 修正問題後，請立即關閉洗衣機並重新
啟動。選擇標準程式，不要加入洗衣劑，
讓程式運作 1 回。
• 有關排水管的連接，請參閱說明書。