Subaru CROSSTREK HYBRID 2016 Owner's Manual page 491

11-42
Maintenance and service/Replacing bulbs
1) Rear side marker light
2) Tail light
3) Backup light
4) Rear turn signal light
4. Remove the bulb socket from the rear
combination light assembly by turning it
counterclockwise.
5. Pull the bulb out of the bulb socket and
replace it with a new one.
6. Set the bulb socket into the rear
combination light assembly and turn it
clockwise until it locks.
7. Reconnect the electrical connector.
1) Guide pins
2) Catch
3) Clip
8. Put the rear combination light assem-
bly into place while aligning the 2 guide
pins and a catch with the guide holes and
a clip on the vehicle.
9. Tighten the upper and lower screws.