Subaru CROSSTREK HYBRID 2016 Owner's Manual page 477

11-28
Maintenance and service/Tires and wheels
4. Put wheel blocks at the front and rear
of the tire diagonally opposite the tire to be
replaced.
5. Take out the jack, jack handle and
wheel nut wrench.
The tools are stored under the floor of the
cargo area. Refer to Maintenance tools
9-2.
NOTE
Make sure that the jack is well lubri-
cated before using it.
6. Loosen the wheel nuts using the wheel
nut wrench but do not remove the nuts.
Jack-up points
7. Place the jack under the side sill at the
front or rear jack-up point closest to the flat
tire.
Turn the jackscrew by hand until the jack
head engages firmly into the jack-up point.
8. Insert the jack handle into the jack-
screw, and turn the handle until the tire
clears the ground. Do not raise the vehicle
higher than necessary.