Subaru CROSSTREK HYBRID 2016 Owner's Manual page 110

wireless equipment is used), or while
talking on a cell phone, the operating
ranges may be reduced, or the keyless
access function may not operate.
In such a case, perform the procedure
described in Locking and unlocking
23.
. When an access key is in the operating
range, if the door handle becomes wet
due to exposure to a significant amount of
water when the vehicle is washed or
during heavy rain, the doors may be
locked or unlocked.
. The keyless access function may not
operate properly depending on the status
of the access key and the radio wave
conditions around the vehicle. In such a
case, perform the procedure described in
Locking and unlocking 9-23.
How to use keyless access func-
tions
Keyless access function tips
. When you lock the doors and rear gate
using the keyless access function, turn the
push-button ignition switch off. It is not
possible to lock the doors and rear gate
using the keyless access function when
the push-button ignition switch is on the
ACC or ON position. For details about
turning off the push-button ignition switch,
refer to Switching power status
Keys and doors/Keyless access with push button start system
. If the door handle is gripped with a
gloved hand, the door lock may not be
released.
. If the door lock sensor is touched three
times or more repeatedly, the system will
9-
ignore the sensor operation.
. When performing the locking proce-
dure too quickly, locking may not have
been completed. After performing the
locking procedure, it is recommended to
pull the REAR door handle to confirm that
the doors have been locked.
. It is possible to lock the doors even
when one of the doors is open. After
performing the locking procedure, close
the opened door or rear gate to lock it.
. Within 3 seconds after locking the
doors and the rear gate by using the
keyless access function, it is not possible
to unlock doors and/or the rear gate by
using the keyless access function.
. When locking, be sure to carry the
access key to prevent locking the access
key in the vehicle.
. The setting of the hazard warning
flasher operation and the volume of the
audible signal can be changed by your
SUBARU dealer. We recommend that you
contact your SUBARU dealer for details.
. The setting of the hazard warning
flasher operation can be changed by
3-3.
operating the multi function display. For
details, refer to Hazard warning flasher
setting 3-66.
Unlocking
Carry the access key, and grip the door
handle.
. When the driver s door handle is
gripped, only the driver s door will be
unlocked.
. When the front passenger s door han-
dle is gripped, all doors including the rear
gate will be unlocked.
Also, an electronic chirp will sound twice
and the hazard warning flashers will flash
twice.
CONTINUED
2-7