When Access Key Does Not Operate Properly - Subaru CROSSTREK HYBRID 2016 Owner's Manual

3-4
Instruments and controls/Push button ignition switch
Power
Indicator color
status
Power is turned
OFF Turned off
The following
systems can be
ACC Orange
audio and ac-
cessory power
Orange
(while hybrid
system is
All electrical
stopped)
ON systems can be
Turned off
(while hybrid
system is run-
ning)
CAUTION
. When the push-button ignition
switch is left in ON or ACC
for a long time, it may result in 12
V auxiliary battery discharge.
. Do not spill drinks or other
liquids on the push-button igni-
tion switch. It may cause a mal-
function.
. Do not touch the push-button
ignition switch with a hand soiled
with oil or other contaminants. It
may cause a malfunction.
. If the push-button ignition switch
Operation
does not operate smoothly, stop
t h e o p e r a t i o n . C o n t a c t a
SUBARU dealer immediately.
off.
. If the push-button ignition switch
does not illuminate even when
the instrument panel illumination
used:
is turned on, have the vehicle
inspected at a SUBARU dealer.
outlet.
. If the vehicle was left in the hot
sun for a long time, the surface of
the push-button ignition switch
may get hot. Be careful not to
burn yourself.
used.
NOTE
. The push-button ignition switch can-
not be switched to
select lever is in a position other than
P .
. When operating the push-button
ignition switch, firmly press it all the
way.
. If the push-button ignition switch is
pressed quickly, the power may not
turn on or off.
. If the indicator light on the push-
button ignition switch flashes in green
when the push-button ignition switch is
pressed, steering is locked. When this
occurs, press the push-button ignition
switch while turning the steering wheel
left and right.
Battery drainage prevention func-
tion
When the push-button ignition switch is
left in the ACC or ON position for
approximately 1 hour, the push-button
ignition switch will be automatically
switched to OFF to prevent the battery
from going dead. This function is activated
when the select lever is in the P position.
When access key does not
operate properly
Refer to Access key
not operate properly
OFF when the
if access key does
9-23.