Turn Signal Indicator Lights; High Beam Indicator Light; Cruise Control Indicator Light; Cruise Control Set Indicator Light - Subaru CROSSTREK HYBRID 2016 Owner's Manual

3-28
Instruments and controls/Warning and indicator lights
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to Replacing bulbs
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
Cruise control indica-
tor light
This light illuminates when the cruise
control main button is pressed to activate
the cruise control function. For details,
refer to To set cruise control
Cruise control set in-
dicator light
This light illuminates when vehicle speed
has been set to use the cruise control
function. Refer to To set cruise control
7-33.
Automatic headlight
beam leveler warning
light (models with HID
headlights)
This light illuminates when the automatic
headlight beam leveler does not operate
normally.
11-39.
If this light illuminates while driving or does
not turn off approximately 3 seconds after
turning the ignition switch to the ON
position, have your vehicle inspected at
your SUBARU dealer.
Front fog light indicator
light (if equipped)
This indicator light illuminates while the
front fog lights are illuminated.
Headlight indicator
light (if equipped)
This indicator light illuminates under the
7-33.
following conditions.
. when the light switch is turned to the
or
. when the light control switch is in the
AUTO position and the headlights illumi-
nate automatically
position
BSD/RCTA warning in-
dicator (if equipped)
This warning indicator illuminates or
flashes when the BSD/RCTA is malfunc-
tioning. In this case the BSD/RCTA warn-
ing indicator will be shown on the combi-
nation meter. When this indicator is flash-
ing or illuminated for a prolonged time,
have your vehicle inspected by your
SUBARU dealer as soon as possible.
BSD/RCTA OFF indica-
tor (if equipped)
The indicator illuminates when the BSD/
RCTA OFF switch is pressed to deactivate
the BSD/RCTA. In this case the BSD/
RCTA OFF indicator will be shown on the
combination meter. For details, refer to
BSD/RCTA 7-37.

Hybrid Fail Lamp

The Hybrid Fail Lamp illuminates when a
malfunction occurs in the hybrid system.