Table of Contents
Advertisement
seconds).
Grip the driver s door handle.
. Rear gate: when pressing the rear gate
opener button
. All doors: when gripping the front
passenger s door handle
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice ap-
proximately every 2 seconds), indicating
that the alarm system has been disarmed.
To unlock all other doors and the rear
gate, briefly press the disarm button a
second time within 5 seconds.
Emergency disarming
If you cannot disarm the system using the
access key (i.e. the key is lost, broken or
the battery is too weak), you can disarm
the system without using the access key.
The system can be disarmed if you turn
the ignition switch from the OFF to the
ON position with a registered access
key.
NOTE
If the access key battery is discharged,
perform the procedure described in
Switching power status
such a case, replace the battery im-
mediately. Refer to Replacing access
key battery
11-45.
Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the access key is used only for
locking and unlocking the doors and rear
gate and for panic activation.
To enter the valet mode, change the
setting of your vehicle s alarm system for
deactivation mode. Refer to Activating
and deactivating the alarm system
22. The security indicator light will con-
tinue to flash once every 3 seconds
indicating that the system is in the valet
mode.
To exit valet mode, change the setting of
your vehicle s alarm system for activation
mode. Refer to Activating and deactivat-
ing the alarm system
Shock sensors (dealer op-
tion)
The shock sensors trigger the alarm
system when they sense impacts applied
to the vehicle and when any of their
electric wires are cut. The alarm system
9-23. In
causes the horn to sound and the hazard
warning flashers to flash for a short time
when the sensed impact is weak, but it
Keys and doors/Alarm system
warns of a strong impact or multiple
impacts by sounding the horn and flashing
the hazard warning flashers, both lasting
approximately 30 seconds.
If you desire, your SUBARU dealer can
connect them and set them for activation
or deactivation.
NOTE
. The shock sensors are not always
able to sense impacts caused by break-
ing in, and cannot sense an impact that
does not cause vibration (such as
2-
breaking the glass using a rescue
hammer).
. The shock sensors may sense vi-
bration as indicated in the following
examples and trigger the alarm system.
Select the settings of the alarm system
and shock sensors appropriately de-
pending on where you usually park
2-22.
your vehicle.
Examples:
Vibration from a construction site
Vibration in a multistory car park
Vibration from trains
. You can have the sensitivity of the
shock sensors adjusted to your pre-
ference by your SUBARU dealer.
2-25
CONTINUED
Advertisement
Chapters
Table of Contents
