To change the setting:
1. Turn the ignition switch to the OFF or
ACC position.
2. Press the trip knob to show
on the odometer and trip meter
display. The display can be switched as
shown in the following illustration by
pressing the trip knob.
*1: They cannot be displayed when the
or
ignition switch is in the ON position.
*2: Displayed only for models with BSD/
RCTA.
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the
meter/gauge needles of your vehicle
has been set for activation
time of shipment from the factory.
Instruments and controls/Meters and gauges
Speedometer
The speedometer shows the vehicle
speed.
Odometer
1)
Trip knob
This meter displays the odometer when
the ignition switch is in the ON position.
The odometer shows the total distance
that the vehicle has been driven.
If you press the trip knob when the ignition
switch is in the OFF or ACC position,
the odometer/trip meter will light up. If you
do not press the trip knob within 10
seconds of illumination of the odometer/
at the
trip meter, the odometer/trip meter will turn
off.
3-7
CONTINUED