Table of Contents
Advertisement
2.3.6
IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you wish to configure the item.
IDE Configuration
Onboard PCI IDE Controller
Onboard PCI S-ATA Controller
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
IDE PIO Pre-Fetch Enable
Onboard PCI IDE Controller [Both]
Allows you to set the onboard PCI IDE Controller. Set to [Disabled] to
disable the integrated IDE Controller. Set to [Primary] to enable only the
Primary IDE Controller. Set to [Secondary] to enable only the Secondary IDE
Controller. Set to [Both] to enable both IDE Controller.
Configuration options: [Disabled] [Primary] [Secondary] [Both]
Onboard PCI S-ATA Controller [IDE By Bios]
Allows you to set the onboard PCI S-ATA Controller.
Configuration options: [Disabled] [IDE By Bios] [RAID By Rom]
Hard Disk Write Protect [Disabled]
Allows you to enable or disable device write protection. This will be
effective only if the device is accessed through BIOS.
Configuration options: [Disabled] [Enabled]
IDE Detect Time Out [35]
Selects the time out value for detecting ATA/ATAPI devices.
Configuration options: [0] [5] [10] [15] [20] [25] [30] [35]
ATA(PI) 80Pin Cable Detection [Host]
Selects the mechanism for detecting 80Pin ATA(PI) Cable.
Configuration options: [Host & Device] [Host] [Device]
IDE PIO Pre-Fetch Enable [Disabled]
Allows you to enable or disable IDE PIO Pre-fetch Enable. Set it to
[Disabled] before testing AMIDIAG.
Configuration options: [Disabled] [Enabled]
2-16
[Both]
[IDE By Bios]
[Disabled]
[35]
[Host]
[Disabled]
Chapter 2: BIOS Setup
Advertisement
Table of Contents
