1.10.2 Internal connectors
1.
IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cable(s). There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to the
motherboard's IDE connector, then select one of the following modes
to configure your device(s).
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
M2S-X
R
M2S-X IDE Connectors
ASUS M2S-X
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode
Cable
of device(s)
connector
-
Black
Master
Black
Slave
Gray
Master
Black or gray
Slave
1-23