Asus Motherboard M2S-X User Manual page 65

TRRD [Auto]
Sets the TRRD. Configuration options: [Auto] [2T] [3T] [4T] [5T]
TRC [Auto]
Sets the TRC.
Configuration options: [Auto] [11T] [12T] [13T] [14T][15T] [16T]
[17T] [18T] [19T] [20T] [21T] [22T] [23T] [24T] [25T] [26T]
Bank Interleaving[Auto]
Allows you to set the Bank Interleaving. Configuration options: [Disabled]
[Auto]
Enable Clock to All DIMMs [Disabled]
Allows you to enable unused clocks to DIMMs even memory slots are not
populated. Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ATLVID [Disabled]
Enables or disables the MemClk Tri-Stating during C3 and Alt VID.
Configuration options: [Disabled] [Enabled]
DQS Signal Training Control [Enabled]
Enables or disables the DQS Signal Training Control. Turning this off will
require custom memory timings programming. Training will be automatically
disabled if CS Sparing is enabled. Configuration options: [Disabled]
[Enabled]
Memory Hole Remapping [Enabled]
Enables or disables the software memory remapping around the memory
hole. Configuration options: [Disabled] [Enabled]
Power Down Control [Auto]
Allows DIMMs to enter power down mode by deasserting the clock enable
signal when DIMMs are not in use. Configuration options: [Auto] [Disabled]
Alternate VID [Auto]
Allows you to specify the alternate VID while in low power states.
Configuration options: [1.550V] [1.525V] [1.500V] [1.475V] [1.450V]
[1.425V] [1.400V] [1.375V] [1.350V] [1.325V] [1.300V] [1.275V]
[1.250V] [1.225V] [1.200V] [1.175V] [1.150V] [1.125V] [1.100V]
[1.075V] [1.050V] [1.025V] [1.000V] [0.975V] [0.950V] [0.925V]
[0.900V] [0.875V] [0.850V] [0.825V] [0.800V] [Auto]
ASUS M2S-X 2-23